24VDC 5-wire Remote Control Pack Conversion

This kit includes (some components have been factory pre-assembled):

The five wire remote is designed to control both the voltage side of the circuit as well as the ground. The previous three wire system only controlled the voltage side of the circuit. The four wiring schematics below will clarify this statement.

Wiring-5-Wire-Conversion-24v-1.png

The remote plug wiring orientation for the control pack is as shown below:

Wiring-5-Wire-Conversion-24v-2.png
Please contact us for inquiries.

The following drawing is for routing the wires in the control pack to prevent heat damage from the bus bars in a 24 VDC four pack configuration.


Note: Identify location of cables prior to removal for correct reinstallation

Wiring-5-Wire-Conversion-24v-3.png

The following drawing is for routing the wires in the control pack to prevent heat damage from the bus bars in a 24 VDC inline pack configuration.

Wiring-5-Wire-Conversion-24v-4.png
Please contact us for inquiries.